BMW B58, B48, B46
The ProECU BMW F/G Series – B58/B48/B46 Gen 2 / Toyota Supra tuning suite supports all worldwide vehicles fitted with the Bosch MG1 TriCore ECU, including:
- 2019–present B58 Toyota Supra 3.0 MkV
- 2019–present B48 Toyota Supra 2.0 J29
- 2019–present G29 BMW Z4 M40i
- 2019–present G29 BMW Z4
- 2019–present G07 BMW X7 xDrive40i
- 2019–present G11 & G12 BMW 740i
- 2019–present G11 & G12 BMW 730i
- 2019–present G20 BMW 340i
- 2019–present G20 & G28 BMW 320i
Please be aware this product will require a bench unlock via the BFlash Tool before a tune file can be programmed in. If you would like to purchase a BFlash Tool or find out which of our tuners can perform a bench unlock for you, please contact sales.
Important – ECUs manufactured after June 2020 cannot be unlocked
Security on ECUs manufactured after June 2020 has been changed and bench unlocking is not possible for them. There are no tuning products in existence that can support these new ECUs.
We are working hard to find a solution to this and nothing is being ruled out as a potential fix.
RaceROM Custom Features
- Four-way Mode Switching
- Swap between four different modes using ECU Connect on your mobile device. For example, Track Mode; Fast Road Mode, E85 Mode; Economy Mode. It’s up to you to decide what set-up you want in each mode.
- Using the RaceROM Boost controller, you can adjust your boost pressure in each mode using the cruise control or ECU Connect.
- One-Touch AntiLag/Rolling Launch
- RaceROM Rolling Launch allows you to roll race at the touch of the button. To set, enter the map switch mode in which Rolling Launch is activated. Press and hold the cruise control set button to build boost, adjust your speed with the accel pedal to match your opponent aaand…release the set button and enjoy! The system can be set up using activation time limits, temperature limits and a minimum re-arm time to try and maintain reliability.
- RaceROM Burble
- Switch between a range of soft to hard burble on the fly, or even disable completely in Sport for full stealth mode.
- Self Adjusting FlexFuel
- No more worries about calculating the ethanol in the tank; our RaceROM self-adjusting flex-fuel does it all for you. Just fit a CANbus enabled Flex Fuel sensor and off you go. Whatever Ethanol content in the tank, the tune will automatically adjust to give you optimal performance. Link up with ECU Connect or use the Sports Display to display the current Ethanol blend. A quick check can be carried out when stationary just by pressing the cruise control button to sweep the tacho needle to display ethanol percentage up to 70%
- Up to 8 CanBus Inputs
- Add a range of external sensor inputs. For example:
- Zeitronix ECA-2 ethanol sensor
- Zeitronix ZT-3 wideband sensor
- Innovate LC-3 multi-sensor
- ECUmaster CANswitch
- Autosport AnalogX
- Custom user-defined CAN sensor
- CAN devices such as the AnalogX allow for multiple variable inputs that can be used to import 0-5v sensors, driver trim switches or even a combination including a 0-5v ethanol content signal.
- Add a range of external sensor inputs. For example:
- Up to 8 CanBus outputs
- Add external drivers or controllers for boost solenoids, water injection, nitrous control, and even secondary port injection.
- RaceROM Sequential Port Injection controller
- Using the Motiv Motorsport Reflex Box, you can bolt-on and control aftermarket port injectors, releasing the power from those bigger turbos and fuel pumps to deliver the maximum performance from your modifications.
- Sports Display HiJack
- Display and adjust your max torque using the sports display or use it as an additional dashboard display to show ECU parameters.
- Valet Mode
- Put the car into a low power mode with limited speed and range, either as a security measure or to allow the car to be limited when handed over to a third party. This still leaves all four Map Switch modes available for your choice of setups.
ECU Connect – Use your Phone to control your tune
Our free ECU Connect App can be used to control some of our custom RaceROM features in conjunction with our ECU Connect Interface. Find out more about ECU Connect here
- Mode Switching
- Switch between four different modes as detailed above on the fly using your phone.
- Launch Control
- Adjust the launch control RPM using a slider on your phone. This is very handy for cars without cruise control fitted.
- Boost Control
- Adjust the above parameters in each mode live using sliders on your phone.
- Custom Features set up by your tuner
- You have up to five features that can be controlled using your mobile device. Configurable as a slider, numerical value or on/off switch, these inputs can be set up to interact with the ECU directly from the driver’s mobile device. Speak to your tuner to discuss what you would like.
- Typical features you could set up are:
- Make your Traction Control more or less aggressive
- Activate your Nitrous
- Set up a Push To Pass button
- Set up a pit lane speed limiter
- Adjust your pedal map
From £700 + VAT
Print 